Well,After some issues with using SNMP andrandom lockups, someone indicated thatthe the 678 has an upgraded CBOS veravailable. Was wondering if anyonecould point me to it as I can't seem tolocate the file here. TIA!

Can anyone tell me what the jumpers, J7, J8, and J14do on a Cisco 827?I'm looking for a Hardware Reset to Factory Defaultssolution.Any help here would be appreciated. Thanks!

Ok, flashed my 678, now only goes into RMON mode.Did the "es 6" and "rb", same thing.Tried to dump mem with "db fef80030", onlyshows "ff" for most of the dump. Any hope forthis? Is there a way to reflash from RMON mode?BTW: gettng this error mesage...

Is there such a thing as CBOS 2.4.7 for the Cisco 678DSL CPE? I seem to see that 2.4.6(what I have) is the lastest, but on eBay of all palces I see a 678with 2.4.7. Anyone know?BTW: Yes, I know the 678 is a bit "dated", but since I managed to "fix"...

Looking for CPE Commander 1.4.2 as referenced:(http://www.cisco.com/en/US/products/sw/netmgtsw/ps783/prod_release_note09186a00800eaa3d.html)However, the downloads section does not contain this file. Does anyone have a valid link to this file?Also, i...