Cisco 678 Flash problem....

[feanacar]

Ok, flashed my 678, now only goes into RMON mode.

Did the "es 6" and "rb", same thing.

Tried to dump mem with "db fef80030", only

shows "ff" for most of the dump. Any hope for

this? Is there a way to reflash from RMON mode?

BTW: gettng this error mesage:

"Operation fault at fee00000, subtype 01

Fault record is saved at 10001010

fee00000 : 4f44213c .word 0x4f44213c"

[umedryk]

Usually the fault can be traced back to a bad or improperly seated transceiver or cable and sometimes a bad hub

Also refer to :

http://www.cisco.com/en/US/customer/products/hw/routers/ps295/products_configuration_example09186a0080093e41.shtml

http://www.cisco.com/en/US/customer/products/hw/routers/ps295/products_configuration_example09186a0080093e34.shtml