Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI!I need to know if there is a way when a user logs in a router or a switch and make a change that change must be logged in some way and all configuration changes must be seen somewhere. I know i can see in the show log that a user changed the confi...
HI, i have a question about VPNs.I have installed a hub-and-spoke topology with a mix of 837 & 836 routers which all connected to the central with tunneling. i have configured the tunnel interfaces and crypto maps and transforms sets and access-lists...
Hi, i am trying to encrypt data through a central site and a branch. The configuration (hopefully) is ok because i can ping the other side successfully. My problem is that when i initiate the remote desktop connection to connect to a terminal server ...
Hi i am new to this forum,my problem is that i have one main office and 2 branches. The problem is that i have created the tunnels in all offices (837 routers) but it seems that the main office doesn't accept any tunnel messages. Instead when the mai...
With the use of RADIUS server isn't possible to audit user actions? only with the use of the ACS server program?Because we have already purchased the radius server for aaa accounting and aaa authorization
Hi, I tried to configure for the dial backup feature over the console port but the Async 1 interface status is down down. I am using the console cable to connect the console port to the modem. Does anybody know if this is the correct cable? I have at...
what about if there isn't any pix i believe that this command refers to pix devices only. Is there anything like this command (timeout conn , timeout half-closed) in a single router ?
I am trying to connect using the IP address of the Internal LAN for example 192.168.0.6. i can ping the server but i cann't connect to it using crypto but only with simple tunnelling.
