Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
If packets need to travel from VLAN1 to VLAN2, do the packets move through the sub-interface on the router or does the router just tell the switch where to send the packets?
The report gets created according to the schedule, but it only creates the report for the Top 20 users. Does anyone know how to configure the "N" for a scheduled report?
When I run User Reports - Bills - Department - Detail, I get results for some subscribers and some don't have any information. I can't figure out why. Areas I've checked so far:Physical connectivity is fine. Switchports for a user that gives resul...
Sorry. I don't quite understand your answer. Let me clarify. I have one switch, one router with one physical interface and two subinterfaces, and two subnets (two VLANS). If host 192.168.0.10 wants to access data on host 192.168.5.10, do packets ...
Thanks, but I'm trying to modify the report that gets run via the "Automatic Generation/Alert" according to a schedule. I enabled the "Top N Calls [Daily]" report, but there is no option in the customize parameters window for "N". It selects the to...
I recently had this same problem. In my case, the phone was first associated with the user Jane Doe, then RMuser for IPCC. The user Jane Doe was replaced with John Doe. I unassociated the phone from Jane Doe, created user John Doe, and associated ...
OK,I know where to go to restart the scheduler, but where do I restart the Art NT Tomcat services? Do I go into the Windows Services and restart "Cisco Tomcat"? Also I noticed that CDR Insert is activated on the CCM Publisher, but not on the Subscr...
