Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Expert,I face a connectivity issue between inside and outside if i'm using FWSM module on my Cat 6509 and please assist me.Below is scenario description~~~~~~~~~~~~~~~~~1. My Inside Network device able to ping all outside network Device Via the ...
Dear All Expert,Good Day.Due to i'm very new in LMS, so I would like to seek for your expertise to solve my problem.After i installed the Cisco LMS 3.2 and double click the CiscoWork Application Icon, but it failed to load.During the installation, i ...
Dear All Expert,Good day.Currently, i have a issue of the DLsw ER+ and i hope that DLSw+ Netpro Experts can highlight/advice my problem.Problem Description:Please refer the diagram - dlsw+.jpg first.Early, my network did configure the #bridge-group 1...
Dear All Expert,Good Morning.I would like to seek for your advice on my below concern.If I migrate below config~~~~~~~~~~~~~~~interface FastEthernet0/0 ip address 172.230.190.4 255.255.255.0 bridge-group 1~~~~~~~~~~~~~~~To Sub-interface fa0/0.1 but w...
Dear expert,Good Day.I have a question about the PPP multilink.Currently, i have 3 serial interface and bound them as multilink 3. But unfortunately serial0/0/0 has error increasing and rest 2 serial are normal.My question is why #show int multilink ...
Dear Jon,Appreciate your guide.I have a better understand for the security level already.<< Device on a lower security interface to talk to a device on a higher security interface you need an acl rule + a NAT rule >>So we must specific ACL rule + NAT...
Thanks your so much, Mr. Jclarke.You help me alot and all my doubt was gone.Just double confirm you, LMS 100% cant support LWAPP AP right, only standalone able. Any cisco Doc state that !?Appreciate it (^_^)RegardsTerry
Dear Jclarke,Good Day.Appreciate your solution, now i'm able to install the Ciscoworks LMS 3.2 properly, and able to auto discovery the device.May I seek for your advice for another question = the auto discovery for the Cisco Access point !?My LMS 3....
