Hi One of the problems is that it cannot be managed by a profile, due to "No OOB" connection on the ACHI  controller. I think i need to set the options in Bios to get this working.   And bios setting for "Boot options" P-SATA does not care about the "Disabled" or "LSI SW RAID" it shows both drives in ESXI 6.7 setup as: "ATA Micron_5100_MTFD (t10.ATA____Micron_5100_M...) 223.57 GiB" "ATA Micron_5100_MTFD (t10.ATA____Micron_5100_M...) 223.57 GiB" I would like to config it to a Raid1 LUN. But how can I do this with BIOS or Profile settings?   240GB M.2 6G SATA SSD is not actually a NVMe disk. Storage Controller PCH1 has this nice feature... or no feature at all to set Raid1 with Policy.  "sys/chassis-1/blade-1/board/storage-PCH-1, Server does not support out of band configuration" "Lewisburg SSATA Controller [AHCI mode]" how do I change AHCI mode to SWRAID mode? AHCI (JBOD) and SWRAID (RAID).   Ivar       ... View more

Ok, I can now see the disks! Setup is this: UEFI Bios boot, P-SATA boot option to disabled, no disk policies. Next I need to set Software raid, so I can run in Raid1. Changing to P-SATA boot option to "LSI SW RAID". Wonder how to set Software raid? Ivar ... View more

Hello Kirk J, Thanks for answering on this! I am running with UEFI bios setup, and just now without any disk policies. The server can take the profile now, but i do not find the M.2 Sata SSD`s  I have set the P-SATA boot option to disabled... in boot options. I may set it to LSI SW RAID...   Testing with esxi installer now to see if it can see storage. I may need to set UEFI boot location on local disk.  \EFI\BOOT\BOOTx64.EFI   Ivar       ... View more