Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Experts,
I always have a confusion with below cmd under different routing protocols like RIPv2, EIGRP and OSPF?
Consider a router "R" with 4 different interfaces directly connected to NW 10.0.0.0/8 || 11.0.0.0/8 || 12.0.0.0/8 || 13.0.0.0/8
Examp...
Dear Experts,
I always have a confusion with below cmd under different routing protocols like RIPv2, EIGRP and OSPF?
Consider a router "R" with 4 different interfaces directly connected to NW 10.0.0.0/8 || 11.0.0.0/8 || 12.0.0.0/8 || 13.0.0.0/8
Examp...
Hello Experts,
I have noticed that interface VLAN doesn't come up till the time I configure one of the switch port as access with VLAN = i/f VLAN & connect one end device like PC through it.
I have two switched connected as below:
switch#1 --------- ...
Dear Experts,
I have one doubt & need your support.
If I have a network connection as shown below:
PC-------SW#1------R1-----SW2-------Server
PC:10.1.1.1/8 ; S:11.1.1.1/8
and PC wanna ping server then how will be the PING steps followed(behind the sc...
Hello Vasilii/ Other Experts,
Good day.
Actually, I was just performing one practice exercise on packet tracer(diagram attached).
I have connected one switch(SW#16 in the attached diagram) from HWIC card(switch i/f of Router11) and have configured tw...
H Peter,
Many thanks for your support. It was very informative and with this definition & purpose of SLOT Time is clear to me.
However, please can you comment once more for below point & my understanding?
Point: The frame size can't be smaller than 6...
Many Thanks Ric..
So, router will not learn MAC from L2 headers.
But if any device will do the ARP for router, then Router will also update its own ARP table with that ARP request?
I mean when PC will do ARP for router, then router will also update i...
Is below understanding correct ?
Based on exponential backoff algorithm, if collision occurs(CSMA/CD NW) then re-transmission is delayed by an amount of time derived from the slot time and the number of attempts to re transmit.
Slot Time: It's the q...
