Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I'm troubleshooting an issue with monodirectional audio.Looking at the rtp trace I noted that the very first rtp packets have sequence number 80 81 82 and the following have seq. number 0 1 2 3 ....Is this the cause of my problem?Is this admitted...
How to check the ADSL speed my router is running?Is there an IOS command to verify the speed clocked on the ATM interface?My ISP sell me a 4Mbps line but I can download at maximum 2Mbbs (verified using some internet tools).ThanksAndrea.
Hi, Is there anybody who know which management solution should I use to manage and monitor a VPN network built by PIX devices?Cisco Works Management Center for Firewall doesn't support pix's VPN commands such "crypto-map".ThanksAndrea Timpanaro.
Hello, I have this configuration: Client|L.D.| \web1 web2web1 is running on port 8001web2 is running on port 8002the virtual server is running on port 80.and this is the configuration:virtual 10.1.1.1:80:0:tcp isreal 10.1.1.2:8001...
Hello folks!I need to connect a Fddi ring to an Ethernet segment.On the ethernet side I have a cat 6509 and many cat 2950GHow can I do?Do you know if there is a kind of bridge that I can use (cisco or not).ThanksAndrea.
Looking at this config:interface BRI0/0 ip address 192.168.2.94 255.255.255.252 no ip directed-broadcast encapsulation ppp dialer idle-timeout 60 dialer map ip 192.168.2.89 name west broadcast 5551234I think there is a problem because the "dialer map...
Yes, you can find it on release notes, for example here:http://www.cisco.com/en/US/partner/products/sw/iosswrel/ps4264/prod_release_note09186a00800805b1.html#94985
Keep in mind that to calculate the metric the lowest bandwith on the entire path is used. So you need to configure the bandwith to make the backup path to be lower than the primary path.
