Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am running a TcL script on a Nexus 7k and would like to suppress the output from cli commands. The TcL book says it can be done by enteringt "log_user 0", which works on a ASR router but not the Nexus switch.Any suggestions would be appreciated.
I need a url match in a CSS (v7.20) content rule to distinguish between these two urls:/sieb_poc/finsobjmgr_enu/!1.b78/sieb_poc/finsobjmgr_enu/!2.b78The command url "/*!1." is not valid.It appears that a letter has to follow the *Is there another way...
I got this when doing an upgrade on a CSM in a hybrid 6500:Any ideas? CSM> upgrade slot0: c6slb-apc.3-2-3.binUpgrading System Image 1CSM ExImage Tue Jul 06 11:18:07 2004Checksum failed; G:cfe4d449 C:cfa4d449ting:session.rom......R|W| Reading:lam_ppc...
Does anyone know the difference between the following two error messages:%LINEPROTO-SP-5-UPDOWN: Line protocol on Interface GigabitEthernet2/2, changed state to down%LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet2/2, changed state to ...
My problem turned out to be a VPC+ issue that occurred after a link to a FEX module flapped
Error message:
%FWM-2-STM_LOOP_DETECT: Loops detected in the network for mac 0015.c5eb.1742 among ports gpc1:302 and gpc1:1301 vlan 148 - Disabling dynamic...
The BERT error indications of bit errors and pattern slips lead me to think that you are losing packets in the path. Have you checked each of the ports involved for input/output errors or dropped packets? It could be as simple as a duplex mismatch.
