Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Guys,I'm planning an update of the QoS policy deployed on the SD-WAN infrastructure. We currently have a hub and spoke topolgy deployed with two edge routers (hub) in each data center. The QoS policy has 5 classes, we need to updtate this polic...
Hello @TIMOTHY SCHWIMER It looks like this is related with a software bug (CSCux11016) that is hitting to the version 7.0.3 and it's possible that was not detected on release 6.1. If you need subinterfaces greater than 511, as workaround Cisco recom...
Hello JackThe default route looks good on R1, however the return route should be applied on your device represented by the cloud on your topology diagram, now if your take in consideration @luis_cordova configuration it is not needed the return route...
[email protected] adding additional information about @luis_cordova mentioned, NAT provides (among other options) a security mechanism on the border of your network, this is crucial with Internet mostly, so using NAT, your IPs (or clients) in your L...
Hello Jack You need to set up a default route pointing to your R1 router's next-hop (the IP address of the device represented by the cloud on your topology): ip route 0.0.0.0 0.0.0.0 X.X.X.X --> this is the IP address of your R1 router's next hop I ...
