Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This command is avaliable in 12.2(18)SXD4 - But I cannot find ANY reference to it on cisco.com, except for "show module provision" which is completly usless, due to the fact that it does not say anything as to what the outpur means.I have a slight fe...
I'm currently testing something on a PFC3A running 12.2(18)SXD1.What I need to do is have a ospf process running, and on that process I would like to configure "passive-interface default" and some interface that are not passive (no passive-interface ...
You can make an ACL that prefers a given service.Lets say you have this:service P1ip address 192.168.10.1activeservice P2ip address 192.168.10.2activeowner testcontent P1-P2add service P1add service P2vip address 192.168.1.1activeNow you want to stic...
Make sure that whatever is connection to the management port is originating from an address that is in the same subnet as the management port address.If not, then the CSS will route the reply back to whatever the routing table suggest as the optimal ...
