Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm getting packet drops in queues when there is no congestion. See the show policy-map below. You can packets dropping in the voice-control queue and its well below the 245k reserved for it and if you add up all of the bandwidth you will see I'm w...
Anyone able to configure Xmedius to set the calling party number for outbound calls to that of the fax DID or CSID number of the user sending the fax over a PRI PSTN?The debug shows that when the call is initiated from Xmedius on the H323 gateway thi...
I had a working Microcell behind an ASA until May 1st. It just stopped working. The device was fine, took it home and plugged it in and it worked great. But would no longer establish a tunnel through the ASA. Spent the last few weeks off and on, ...
That is our setup as well. If you want your gateway to the PSTN to be MGCP then as far as I know this is the only way to do it. Xmedius will only connect to a h323 or sip gateway. I think it is little off too. If xmedius could/would support MGCP g...
As far as I know, Xmedius T38 will only work with a h323 or sip gateway. You will need to another router to act as the gateway and connect it to the MGCP gateway or reconfigure your MGCP router to H323 and lose your caller name info and the other ni...
