Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I just installed cisco meeting express in DMZ and I am wondering which ports are required to be open for ethernet Port 1 (used for voice and media http signaling and for the end user interface / admin center)and ethernet port 2 for web conferencing
I'm going to setup ezvpn tunnel between 871w router to concentrator 3005.I also want to create 2 WLAN (ssid) on the 871W. One ssid that goes thru the tunnel (that will be my corporate ssid) and the other ssid (guest) will access only the internet....
I would like to setup my 501 with ezvpn in network extension mode to: 1.Establish vpn tunnel to PIX HUB2. Establish voip 7940 to call managerThis what I have applied on the pix 501 vpnclient server 6.x.x.x 2.vpnclient mode network-extension-mode 3 ....
This what I have applied on the pix 501 vpnclient server 6.x.x.x 2.vpnclient mode network-extension-mode 3 . vpnclient nem-st-autoconnect …. Specifies to automatically initiate IPSec data tunnels when split tunneling is configured. Note that IPSec ...
Want to know the proper way to configure a trunk on a cisco cat os switch... I'm ruunning a Linux server with the monitoring utility Nagios and I need it to access all my VLANS.Ex:Running On my Linux Server 2 network Interfaces on 10.30.32.11 and 1...
Itis doing nothing at the moment ...previously when the hub pix 6.3 (4) the phone recieved a 10.60.60.x ip address ... below is this dhcp pooldhcpd address 192.168.52.2-192.168.52.33 insidedhcpd dns 206.13.28.12dhcpd lease 3600dhcpd ping_timeout 750d...
I'm looking to do either solution as well. I know this is not the place ( I can post a new message) butI would I goabout configuring the 3005 concentrator for ezvpn in network extension mode. This what I have applied on the pix 501vpnclient server 6....
