Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a setup that I need help connecting.I got a cisco router and cisco FTD firewallI’m having trouble connecting them.the router needs to talk to the FW. It has a static route to the interface of the firewallthe firewall has a single “Allow All” r...
Need Assistance .... OSPF Too Many retransmits.... MTU not the cause I'm trying to get OSPF running on a firepower device connected to a router.The OSPF adjacency looks like it was created, but no routes are traded and I keep getting the following er...
I'm new to Virtual environments and I need just a little guidance.I just installed FTDv in VMware and I have everything booted up and I am at the main page.I see the management interface is GREEN but two of the interfaces are AMBER with "X" in them, ...
So I am configuring a couple of FTDs in a lab environment. I went through the steps of creating the VPN connection, but I cant get them to establish the tunnel. I will lay out my process below. My set up is as follows:2 - FTDs1 - L3 Switch2 - PCs Lab...
So I'm new to FMC and I'm trying to get a grip on how things work. I have an intrusion alert that keeps coming up. "HI_CLIENT_DOUBLE_DECODE (119:2:1)"Problem is, it keeps alerting on non-malicious traffic (all internal traffic). How do I turn off thi...
Ok I’m about to try that now.do I need to direct the internal interface to the next hop?basically:ip route [internal interface/24] [ISP]or ip route [external interface/24] [ISP]and vise versa to route into the network? hope that makes sense.
It wont let me answer you in the DM....there is a FW is a NGFW 2130 and a router C8300 and I am trying to create an OSPF connection between them. The connection is established but I cant see any routes traded and I get the error mentioned in my OP
I had a similar issue and it was fixed by matching speed and duplex on both sides of the connection. I had 10G settings on a 1G SFP and 1G connection. I changed them to match all the way through the connection and the SFP and connection came up. Wont...
