Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
CiCisco router on one side, Zebra running ospfd on freebsd 6.2 on the other, Ethernet interfaces. First 30 seconds all is good, then everything stops for a split second and it's good again, this repeats continuously. I see this on the Cisco side bu...
I have a C2950G-12-EI which supports dot1x port based authentication. But the Radius server is in another subnet and the switch doesn't support routing. How do communicate with the Radius server if I can't ping past the local subnet and the Radius s...
a C2651XM router running IOS 12.2 appears to have an odd bug that I can't find listed. sh run<snip> remark DENY AND LOG THE REST deny ip any any logsh start<snip> remark DENY AND LOG THE REST 6000 deny ip any any logNotice in this named ACL, the n...
I need to make a large number of ACL changes across many routers on our WAN. I was hoping to do this through a script (no money for fancy tools): telnet in copy running to TFTP server modify ACL on TFTP server through another script copy TFTP to run...
This is what I thought. I must be missing something simple here, how do I specify the local subnet's default gateway on the Switch?RADIUS SRVR <-> RTR1 <-> RTR2 <-> Switch
I'm confused then, why do 29 out of my 65 routers show numbers in the named ACL's when doing a show startup and the others don't? Makes it hard to compare running and startup configs to see if anyone has missed a wr mem or something.
I think Scott was thinking of a Linux box with no addressing turned on. Strictly in bridged mode, no cracker could target it (unless they where on the same segment) without an IP address. Reports would have to be done locally then. But this is a g...
