Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello!I am trying to get a router set up (cisco 2821). I will include the config below. What i happening is that I want to be able to ping our internal equipment from the PC connected on the network. I can get out to the internet from said PC, but ca...
Hello. I am a beginner with BGP and I am running into an issue. We currently have two ASR 9000s (each in a different POP) connected via iBGP. We have two 10gig links going out of one 9000 (Main RT) and one going out of our second 9000 (Second RT).The...
In November, our company was one of the lucky few who can hacked by the vulnerability tracked as CVE-2023-20198. We removed the 9600 off of our network and patched it to the fixed version. I am trying to find out if there is anything else we would ne...
Hello.We have two 10gig circuits connected to our ASR9000. Two different ISPs going in two different directions. Our traffic is going through one of the 10G circuits, while the other was being used as a backup. We now want to use the second circuit f...
Hello, We currently have a BGP session established in our ASR9600 with an ISP over a 10G transport circuit. We are turning up a second 10G circuit with the same ISP. I know we can set up a LAG with the two circuits, but is it possible to just set up ...
I understand that prepending the neighbors I don't want to use will push the traffic to that one neighbor. What I am trying to do now is get inbound traffic coming into Neighbor 14.0.0.1, while possibly keeping inbound traffic going across the other ...
