About rplacier

rplacier · 03-09-2012

I have several 2950 switches that I cannot get to work with TACACS. I'm using the same config for these that I am using for other cisco switches.Cisco Internetwork Operating System Software IOS (tm) C2950 Software (C2950-C3H2S-M), Version 12.0(5.3)W...

rplacier · 03-14-2011

How do you block a mac-address on a cisco 1700?Thanks

rplacier · 02-25-2011

I am getting the following error message on our 10700 router: %SYS-2-MALLOCFAIL: Memory allocation of 276 bytes failed from 0x50314770, alignment 32 Pool: I/O Free: 60224 Cause: Memory fragmentation Alternate Pool: None Free: 0 Cause: No Alternat...

rplacier · 06-18-2007

I have a 3750 switch that, every once and a while, all the lights go amber at once which blocks all ports for a few seconds. I am wondering if "spanning-tree portfast bpduguard default" has anything to do with this problem. I also have portfast turn...

rplacier · 02-25-2011

Thanks for the assistance. I'll upgrade the IOS and reload the router. Hopefully this will take care of the issue.

rplacier · 06-18-2007

Uplink interface is clean and there doesn't seem to be any abnormal errors on any other interface.

rplacier · 06-18-2007

I have swamped out the switch once and both times there have been no error messages in the logs.

Member Since	‎02-22-2006 02:56 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	7

User Statistics

User Activity

Cisco 2950 TACACS+ issue

Blocking a mac-address

error message in log

All lights go amber

Re: error message in log

Re: All lights go amber

Re: All lights go amber