Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have the following where a MAC is to be limited to a port on VLAN81.interface GigabitEthernet3/0/31 description Restricted Device switchport access vlan 81 switchport mode access switchport port-security switchport port-security violation restrict...
Multilink input rate registers double the conbined rate of the 2 T1 interfaces. Seen on 15.1 and 15.3 code so far. Is this a known bug? Unable to locate a possiable associated bug#.a.) Traffic rate is also showing on SNMP applications such as Sola...
We have a 2911 with an EHWIC-D-8ESG-P and SRE-900 installed. A PC is connected to Gi0/3/0 and an upstream L3 switch, with a configured VLAN21 interface, is connected via Gi0/0.21.The router can ping the upstream VLAN21 interface of 10.11.16.1 but ca...
There is no CCO IOS present for this bug in 15.2(4)M. It will be available in and above 15.2(4)M4. Fixed-In Description: Fixed-in15.3(2.14)S15.3(2.7)T15.2(4)M3.415.3(1)S1.615.2(1.2.3)PI2215.3(2.8.1)PIB2315.3(2.15.1)XEB15.3(2.9)T
No. I have found note regarding bug CSCtz48125 in which the multilink input was reporting half that of the physical ports. It would appear that the code correction may have been applied incorreclty to both input and output of code sections and now t...
All is working. Thanks for your assistance. It is greatly appreciated. Test laptop on Gi0/3/0 able to ping VMServer at 10.11.16.92 and gateways at 10.11.16.1VMServer able to ping laptop and gateway.
The laptop still is unable to ping the Gi0/0.21 or upsteam interface 10.11.16.1**********************************************************Configs added to the router:bridge irbinterface GigabitEthernet0/0.21 description PrimaryLAN encapsulation dot1Q ...
