Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has anyone seen this log message beforewhen attempting to configure a 2-port layer 3 EtherChannel on the same line card (WS-X6148-GE-TX), the following syslog messages were generated. Aug 12 16:15:58.497 EST: %PM-SPSTBY-3-INTERNALERROR: Port Manager ...
I have just configured extension mobility and I have the following issue. When I press the services button my extension mobility option appears onscreen but when I press select nothing happens. Can anyone point me in the right direction.
Looking for some assistance with the following messageThanks in advance%SW_MATM-4-MACFLAP_NOTIF: Host 001f.caa4.bc00 in vlan 103 is flapping between port Fa1/0/23 and port Po16
Hi to back up the fact that the issue is at the far end this is the output from the frame debug which is showing the packets traversing the interface. What do you think?133287: Oct 8 15:37:12.827 UTC: Serial0/0/0.16(o): dlci 16(0x401), NLPID 0x3CC(...
I have turned on debug ip icmp and get no output when i ping the interface all other interfaces are ok. I have tried an extended ping but the result is the same.The frame link would seem to be up okMain InterfaceSerial0/0/0 is up, line protocol is u...
