Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have problem to configure my Cisco router to work in a LAN with one more 3G router.LAN is connected to the 3G router which forwards traffic to Cisco which is used as a gateway to Internet.Cisco has default route to its WAN1. ip route 0.0.0.0 ...
Hi,I have problem with my PPP connection. Router detects network, provider, signal strength and that is all ok. But my GSM profile is INACTIVE. How to activate it?cellular 0 gsm profile create 1 APNTest ppp pap usertest pass123Profile Information====...
Can 1310 be deployed in bridge mode (point-to-multipoint) with several 1241AG(which are in workgroup bridge mode)??? All APs are autonomous.With what APs is 1310 compatible as a bridge-to-bridge?
Hi,I have central site with 50 users, without branches. Can I deploy just NAC-NM instead of CAS and if I use NAC-NM in 2811 ISR is there any bandwidth limitation when it is compared to CAS solution? In general, what is throughput for CAS (3310) and w...
Hi,I changed PDP type to IPv4rest of the configuration ischat-script INTERNET "" "ATD*99***1#" TIMEOUT 60 CONNECTinterface Cellular0 no ip address ip virtual-reassembly encapsulation ppp load-interval 60 dialer in-band dialer pool-member 1 async mode...
I'm talking about servers at the local side, ok they aren't affected after authentication. But what's the exact throughput of NAC-NM in ISR 2811 in in-band deployment, including throughput of the router itself ???
It's clear that number of users with NAC-NM is limited by the licence, 50 or 100 users. But is there any impact on traffic congestion when I put module in ISR? Does it affect availability of my servers for example?
