Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
%IOSXE_SPA-6-UPDOWN: Interface TenGigabitEthernet0/0/1, link down due to local fault.
I read a post that says:
I sorted out the issue with the below command since they work in WAN mode by default
"hw-module subslot 0/0 enable LAN"
But what hap...
I have approximately 50+ VLAN's setup on my network already. 3 off those I have in different floors and different VLAN's, and my boss wants to isolate them from the internet, but be able to access different webservers within other subnets outside th...
I have a Cisco 3945, it has on it two DS3 lines which I like to treat independent from each other.I can ping both Serial interfaces from the internet, and I can ping only GIG 0/0 from the internet. but since the router is configured with one static ...
some of the logs out of the unit
state to down*Apr 7 13:45:31.723: %LINK-3-UPDOWN: SIP0/0: Interface TenGigabitEthernet0/0/1, changed state to down*Apr 7 13:53:22.728: %IOSXE-4-PLATFORM: R0/0: kernel: ERROR: SPA bay 0 has no GPIO*Apr 7 13:53:22.72...
cisco ASR1001-X that command didn't take
if I do a show controllers this is the result
TenGigabitEthernet0/0/0 3 input vlan errors 1 Number of sub-interface configuredTenGigabitEthernet0/0/1 2 input vlan errors 0 Number of sub-interface configuredGig...
Say Slot 0/0/0 resides on the WAN side
how do you make slot 0/0/1 to be on the LAN side
as your command "hw-module subslot 0/1 enable LAN" I think would force both interfaces to be on the LAN side.
Hi Marvin,
I was already thinking of sending the syslog over to an external server as an option, but if I was to do that, the internal syslog will remain in case of failure on the external ?
