Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have just installed a 6509 and put all o f the ports in card2 into VLAN 110. this has an ip address of 10.244.33.1 on card three is VLAN1 (Native) and this is on the 156.73.8.1 address. ON VLAN 1 is a DHCP server and on VLAN 110 there isn't but I ...
I have posted this problem in the AAA forum as originally I though this must be a triple A issue.I am trying to replicate two ACS servers across an ASA5500. If I take the ASA out of the configuration, the two ACS servers will replicate with no probl...
We have two Data Centres with the primary ACS server in one and I am trying to install a secondary ACS server in the second one.They communicate at a TCP level but I can’t get the second ACS to replicate the first one. They are both installed on win...
We have two CSS 11150s running ap0500066s and working fine. As part of a project, I need to get another CSS onto the network and working before I take down one of the original CSSs. The third CSS now has the new config on it but the software level ...
There has to be a better way than this......I have just spent 3 hours putting a pre-written config on this CSSI have a CSS 11050 with about 80 or so services running on it and about 50 content rules. The most efficient I have managed to get so far i...
HI jon,The DHCP server isn VLAN1 is a different one to the ones I am pointing the IP helper at. We are migrating the users from the 156 address range to a 10 address range. Yes the pC was on a port connected to VLAN 110.interface GigabitEthernet2/2 ...
Jonny,We have done this by using sub-interfaces, but assuming you have only the 192.168.1.x network connected to the ASA, you can add a static route to point 192.168 2.x packets to the router connecting the two interfaces.CheersTim
Thanks Jackko,Yup the interfaces are set to same security permit…. They are both subinterfaces and are both set to 50I have now put a sniffer on the other side of this setup (ACS2 side) and see just 3 packets. A syn from ACS1, a syn ack from ACS2 a...
Thanks for that.There is nothing in the logs other than "replication failed, ACS02 did not respond"This problem has moved on a bit as it now seems the ASA between the two ACSs is spoofing traffic. I have reposted the complete story in the Firewall s...
