Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am installing a stack of five C9200-48P switches and have two issues: 1- although C9200-NM-4X is installed in two of these switches, I cant see it in the output of "show module". Is there any command to verify the existence of this module? GAASW02#...
In windows 7, it was easy to edit all security settings for any SSID by simply clicking on any known SSID. But in windows 10 only limited sittings are shown when editing the properties of any known SSID.
The only way I found if I am not sure about...
actually, it shows in "show inventory", but I am still confused about port numbering. I can see these ports in all switches, even the ones without uplink module. GigabitEthernet1/1/1 unassigned YES unset down downGigabitEthernet1/1/2 unassigned YES u...
Thank you Walwar, but this is also when machine is connected to that SSID. I am trying to edit and modify these settings even if machine is not connected to any SSID and without deleting and creating the SSID again.
This is needed for troubleshooti...
I can see all details from Wireless Adapter properties once connected to that SSID, but I need to see details and modify them even if not connected to that specific SSID, same as Windows 7
Thanks Walwar, but this is about creating a new SSID, not editing security parameters of the current one. The way most universities present this is how to create a new SSID, and delete it if you want to modify any thing. I am looking for a way to edi...
