Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have connected up a 2960G twice and each time segments connected on a edge switch that is turnked into the core, Most hp printers with jetdiriects stop printing, and are not able to ping. Mac addresses in the arp table show all zeroes on a win2k ...
I have a pix 506 that has a ipsec tunnel to a 3030 concentrator. When the session drops about once a month. I have to reboot the pix. Can we setup a timer or some criteria for the tunnel to reconnect one the interesting traffic tries to traverse the ...
On the vlan that has the problem the servers,printers and users are on the same vlan seperate switches. You cannot ping the printers , pc's switches and servers are pingable.The pc and printer can even be on the same switch.
Years ago there was a fairly useful tool that you ran your config against. It cleared up 95% of the configuration.Try this linkhttp://www.cisco.com/en/US/products/sw/cscowork/ps3992/products_user_guide_chapter09186a008014b1e5.html#wp998787
We run trunks into our esx 2.5 and 3.01 servers.Vmware clearly states they cannot create a brdige loop.We running spanning tree portfast on the trunks.No problems.There is a whitepaper on the vmware site, as well as ppt presentations from vmworld 20...
Sounds like distinct subnets that are totally segregated, The routing should be fine, trunk only if you need higher aggregated bandwidth by using a etherchannel will 50mb across the fiber meet your needs.
You should probably also use version 7 and asdm to configure your pix. By default icmp is not allowed in on a pix.Have you set up your nat pool or a pat address for outbound traffic. The pix will allow everthing out and to return unless you prohibit ...
