Hi All, we have the following scenario. 2 Firewall Active/Standby are facing 2 routers configured with HSRP.is it possible in order to achieve LOAD Balancing for certain destination traffic to have 2 static routes having same AD but different next ho...
Hi All, I wanted just to check the impact of running 2 PIX 535 as Active/Standby with different Image 7.2.2 and 8.0.2I am getting only this warning:Any feedback is appreciated.Jean ************WARNING****WARNING****WARNING****************************...
Hi All, The below interface on the PIX 535 is having a lot of CRC and input errors. what can be the reason ? and how to solve it? let me know if any further information is required.Interface Ethernet1 "3PGW", is up, line protocol is up Hardware is i...
Hi All, we have a VPN service module that doesn't support AES 256 bits. is there a way to overcome this limitation by uploading a key? how can we do it if feasible?thanks Jean
Hi All, we have a 7609 chassis where we have installed the FWSM module and IPsec VPN module.we would like to configure a Site to Site VPN. how do we do that now ? Below is the VLAN interface configuration (outside)on the fwsminterface Vlan601 descri...
yes this is true but my goal is to achieve the Load Balacing via 2 ISP connected each one to the external border router ? can I achieve this by using the above approach ? what's the recommendation ?
No.Just let me tell you our target. It is to migrate our 535 PIX Firewalls to the new 7609 FWSM along with the VPN service modules.The output of "show module" shows indeed that the module was recognized and it's ok.7 2 IPsec VPN Accelerator ...
Thanks Srue for your prompt response. I have already this link but i wasn't able to figure out how to configure my VPN in my case.you can see below my FWSM configuration:fwsm Configuration -------------------!interface Vlan601 description INTERNET C...
