Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a FWSM with 2 contexts. The OUTSIDE interfaces are each in their own L3 vlan and in a common VRF. (ie: both next to each other looking out)I am having a problem getting traffic from one FW to go out C1 and enter C2. I can ping all the outside ...
can anyone recommend a good syslog program to use with the Cisco FW. The ASDM syslog viewer is fine for online use but I am looking for something simliar that can keep some history. I've looked at a few but none were too user friendly for filtering t...
I attempted to install the vpn client (560) before installing the MS patch. It failed installation but now I cannot re-install it as it gives the following message. "Error 28000: Before installing the Cisco Systems VPN Client 5.0.03.0560, you must un...
I have a OOB Real IP GW setup on v4.1.2I seem to have a problem with the CAS connecting to the CAM although I have added the CAS to the CAM and can manage the CAS from the CAM.I noticed while troubleshooting client authentication that the client was ...
I have purchase 2 515E's in failover bundle. They are configured with v6.1 and I want to upgrade them to v6.2 so that I can run standby over the LAN instead of failover cable. I have upgraded the software on the active PIX and I cannot upgrade the SW...
Steven Williams Enthusiast02-19-2019 06:32 AM I have moved to a completely different design that I have worked with Cisco and DUO with and we have decided it was the best design for my scenario. In my scenario we moved to the Cisco ASA doing the...
For those interested and still looking into this. Since ISE v2.1 you can use Auth Vlan feature (Release Notes for Cisco Identity Services Engine, Release 2.1 - Cisco ) to provide CWA and posture support for Ruckus deployments. I've used it and it wor...
Hi Alberto I'm seeing this same problem on ISE 1.3. Could you please explain your solution in a bit more detail as I'm struggling to understand what you did to fix it. thanksTrevor
Just to close the loop on this. Back then I eventually reinstalled my OS and followed the instructions carefully and it worked perfectly. This is a bit of a radical approach so perhaps first try the URL's posted by hadbou above.
