Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Setup: I have 2 PE routers. PE-a and PE-b both connected to CE's(setup with EIGRP)that are advertising default routes to PE-c and currently PE-c is preferring PE-b due to natural iBGP selection process. Currently PE-c is running EIGRP with the CE as ...
Anyone know how to enable Multicast on specific VLAN's only. I have a 4507 switch which is trunked to a 7206 router where different VLAN's are supported through it(VLAN's are separated at the router using VRF's / dot1Q). I'm trying to figure out how ...
I'm trying to configure a 1721 using the AUX port with external USR modem to dial up to a MS-RAS server as a backup. Everything dials fine and it goes through the necessary modm handshake etc.. but my async interface just disconnects/resets for somer...
Thanks for the info. I'm new to Traffic Engineering, I get the egress PE part but I'm a little confused on the ingress. I know how to create a Tunnel but after I create the tunnel how do I config the tunnel to prefer one route over the other?
Thanks for the info but I was wondering if you can assist with a different scenario. If I had another location for example on PE-d and I wanted that location to use PE-a as a default gateway and PE-c to use PE-b, with the metric being that PE-b is th...
