Hi maurogatti,Since i dont see your line protocol up. Are you sure your dsl signal is present on the line? And do you have adsl over isdn or over pots? The 877 is for analog (pots) and the 876 is for isdn.Good luck

hi,as far as i know unfortunately you will have to enter a nat rule on a per port basis. I had this same issue as well. It is possible to enter port ranges in acl's but not here. Of course you could use the up arrow while in config mode so it shows y...

hello andrew,does the console port show you any output while this happens? Have you tried a debug for example on one of the interfaces? and what version of the ios are u using? Ill be glad to hear from you.kind regardsjeroen

hi teru-lei,I have no experience in configuring it in that way. But it looks to me that you might want to try to setup the router as a ca server to solve the issues.as i said i have no experience on that but try to have a look at the link provided be...

Hi,you might find this link interesting as it describes your situation. Only difference is that the authentication in the example is done by microsoft ias (radius). You should also be able to do the authentication by internal userdatabase in the rout...