Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am in the process of building a building 4500 series building switch. I am looking at the 4507R with the Supervisor V-10E with the 4x1GE or 2x10GE. Are there any key issues with this equipment to watch out for?Josef.
I am new to "Additional Access" on Cisco.com. Could someone explain to me how Cisco.com's Partner-Initated Customer Access (PICA) system works?Yes, we have access to the IOS images, CNA, Ciscoworks and the rest but what do you pay for (if at all) in ...
I am missing IGRP on one of my routers, a 2610. Any attempt to configure IGRP is not accepted. And a router help command gives me the output below:Router(config)#router ? bgp Border Gateway Protocol (BGP) eigrp Enhanced Interior Gat...
If you are using SecureCRT you can get started here:1. http://www.vandyke.com/support/crt/scripts/senddata_vbs.txt (VBScript)2. http://www.vandyke.com/support/crt/scripts/senddata_js.txt (JScript).
>The nics are set for auto. I see an error for Smartports not setup. I do not know how to set that up yet. Gary, we have deployed several of these and this is a classic issue. As Glen mentioned, the hosts must match the switch port configuration. The...
Hello Cheh,A part number does not exist for this becase Cisco "does not make or provide the RJ21 connector cable" (see http://www.cisco.com/warp/public/788/AVVID/config_cm_smdi.html).I would just call them "FXS Telco amphenol connectors"-JosefPS - Pl...
It could be that port security set for shutdown when unauthorised MACs are connected.Its generally a bugger to get the switch back up without reloading. Check your config. If it is indeed this, you can bring it out of this state by entering the errdi...
