I'm based in UK and we've just had a T1 (1.544Mb) installed from New York to London. Our UK provider has terminated as G.703 (RJ45) instead of X.21. What interface do I need for the Cisco 1841 router. Thank you
Mu understanding is that if you have policy based NAT in your config you cannot configure using the PDM on v6. We are about to install VMS, and I'd like to know if VMS will have the ability to support policy based NAT on pix v6
We have a E1 installed and when i issue the sh int command i get 2BW 1544 Kbit" rather than 2048. Is the line speed picked up by the telco kit, how do i get it back up to 2 mb?thanks
I've recently created a group of users to only be able to shut and unshut interfaces using the aaa authorize config-commands and have all the relevant groups etc.. in place and working. My problem now is that the new users can now log into any device...
Hi, Thanks, but the T1 is on the US side, we are in the UK and it will be 1.544Mb, so I am assuming it will be channelised E1??Any ideas?Any help appreciatedthankslee
so are you saying that although the "show int s0/0" says 1544 i am actually getting 2048?The bandwidth command will only affect upper protocols like EIGRP right so that will make no difference if i add it to my config?
