Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi eveyrone, im having troubles understanding the use of no-ecmp-mode command , can anyone please give a suggsetion of a lab topology where i can see the use of this command. Thanks in advance.
Hi EveryOne, If a router goes active for a destination, and if before it receives all its replies it detectes a delay increase for the same network it goes active for, the router will wait to receive all its replies, and then check if the best receiv...
Hi Guys Hope you're all doing well.
I have a problem when authentifying a user that have blank sapce in his AD username (like: bob stev), the username exists in the AD but is not authentified in ISE.
Thanks for your reply,but when the router first goes active it puts itself in the A3 (Successor Origin) or A1 (Local Origin) active states,and if another distance increase is detected the router change the state from A3 to A2 (Multiple Origins), or f...
