Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Experts,I have read that auto-rp works with sparse-dense mode only ...if you need this feature with sparse mode then we will have to use the command ip pim autorp listner in global config mode ( I am running 12.4 advance ip services on 3845 )........
Hi Edi,Thanks for responding back on this, yeah I checked with debug ip pim autorp....router on sparse mode does receive auto rp message and "sh ip pim rp "and "sh ip pim rp mapping" shows the correct rp address they have taken it via auto rp and I a...
1. This will send the encapsulation header for outgoing packets through a destination port2. This will send the frames without tagging.There are 2 types of VLAN ID's used by the switch. 1. Trunk Vlan ID (Which is used as tag on the trunk links)2. Po...
The recommended Cat OS version for the RSM is 6.3(3).Check http://www.cisco.com/univercd/cc/td/doc/product/lan/cat5000/c5krn/sw_rns/78_5861.htmI hope upgrading the Cat OS should take care of it.RegardsAmit Singh
Tom,You actually cannot see the ip address of the servers on the switch. You can see the mac-address of the server binded to a particular port but not the IP address.HTHAmit Singh
Scott,In that case he has to configure NAT overlapping on either of the router otherwise it will not work. The best possible way for this would be changing the clients on the remote router to 10.3.0.0 subnet and this will work perfectly. This is not ...
