Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
Does QM_IDLE mean that phase 1 & phase 2 has been established? Or does it just mean phase 1 have been established?
cisco-pre-mmh#show cry isa saIPv4 Crypto ISAKMP SAdst src state conn-id status10.2.0.1 200.84....
Hi, I will be building a site to site IPSEC VPN tunnel with an external party who is using a dynamic IP address. He is using dyndns to associate a domain to the IP. May I know what are the issues of having a remote party using dynamic IP address? Doe...
Hi,
I would like to set up NAT on a stick. How can I do it on CSR 1000v? Any working examples would be good.
policy route-map command is what people have commonly use to NAT traffic based on destination.
However, the command is not available on C...
Hi,
I have set up Cisco CSR 1000v on Amazon cloud (RouterA).Another IPSec device, pfsense - 123.123.123, was also set up on Amazon cloud. I am having issues connecting CSR to pfsense, mainly because pfsense is taking the peer identity as 10.2.0.132 i...
We have many remote VPN partners connecting to us using IPSEC.
Only 1 active CSR (10.4.0.0/24) would be active.
Traffic is first initiated from one of our web servers (www1 & www2) to the remote servers (192.168.1.1/32, 172.16.1.1/32) using the acti...
Am I right in saying that once you see a set of negotiated crypto settings in "show cry ipsec sa".
That means phase 2 is up?
What if the encryption domain is wrong? Would phase 2 be still up?
Hi
It seems to give me different error messages when i change the remote peer ID to private address:
! 122.122.122.122 (Router A) - internal IP 10.2.0.132! 123.123.123.123 (Router B) - internal IP 10.4.0.241
pfsense logs
Dec 9 08:41:00 pfSense char...
I am using CSR 1000v on Amazon to establish IPSEC VPN tunnels with remote VPN partners.
Some may require us to perform source NATing prior to sending it through the tunnel.
Any advice on how I can do that ?
