Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all.I was trying to connect our two new 4503 switches to each other via port g1/1-12 on the supervisor modul..Mod Ports Card Type Model Serial No.---+-----+--------------------------------------+----------...
hi all...I have a dns server on outside and a dns server on my dmz.. they are sending updates between each other..Problem is that this update that normaly take about 1 or less second are trough the pix using up to 20 min..This is logg6|Oct 24 2006 08...
Hi..I am wondering if something is posible to achive. I have two core switcher. They are running L3 between them and L3 down to distro switches.Then I also have vlan 1000 on both that are both connected to pix?s that are running active/standby. this ...
Hi all..I have two new 4503 cat`s with Sup II+TS 10/100/1000BaseT supervisor module in.. This is set up in slot 1 of the chassie... the modul have 12 GE ports (RJ45) and 8 SFP ports..I am not able to get the interfaces in up mode. I have put in a RJ4...
Hi all...I have set up my asa accepting vpn clients in from outside... My clients get their adresses from a pool 192.168.22.0/24.ip local pool VPN_CLIENT_POOL 192.168.22.1-192.168.22.255 mask 255.255.255.0Then I have a net that are behind another rou...
I am not sure, but you maybe have to clear your xlate table when that ip adresse have been changed. I am not sure if the pix notices that the ip adresse are changed dynamic and times out that entery. It wold time out if you changed it manually. You c...
I have found the problem.. these ports dont support autodetection of the cable type, so when i put in a straight trough cable here between the switches it did not detect it.. I pluged the cable in top my computer and the line came upJens P
L3-Core#1#sh mod all Chassis Type : WS-C4503Power consumed by backplane : 0 WattsMod Ports Card Type Model Serial No.---+-----+--------------------------------------+------------------+----------- 1 20 Su...
All ports are as they should be.. here are the config:vlan 1000 is not administrativ down. so are not vlan 1...Problem here is something else than this basicsw 1interface Vlan1000 description ### Mot Internett brannmur#1 ### ip address 10.0.1.1 255.2...
i have even tried to disable this although I dont think this have anything to do with this.. It did not either do anything for me. anybody that knows what could be happening here?JP
