cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
472
Views
4
Helpful
1
Replies

interface on supervisor modul not up

jenseike
Level 1
Level 1

Hi all..

I have two new 4503 cat`s with Sup II+TS 10/100/1000BaseT supervisor module in.. This is set up in slot 1 of the chassie... the modul have 12 GE ports (RJ45) and 8 SFP ports..

I am not able to get the interfaces in up mode. I have put in a RJ45 in port 1/12 of each switch connected to each other.

L3-Core#1#sh module all

Chassis Type : WS-C4503

Power consumed by backplane : 0 Watts

Mod Ports Card Type Model Serial No.

---+-----+--------------------------------------+------------------+-----------

1 20 Sup II+TS 10/100/1000BaseT (RJ45), SFP WS-X4013+TS JAE10318CQ5

2 24 10/100/1000BaseT (RJ45) WS-X4424-GB-RJ45 JAE102022K6

M MAC addresses Hw Fw Sw Status

--+--------------------------------+---+------------+----------------+---------

1 0018.187a.5fc0 to 0018.187a.5fd3 1.5 12.2(20r)EW1 12.2(25)EWA4 Ok

2 0016.c73c.ed28 to 0016.c73c.ed3f 1.8

interface GigabitEthernet1/12

switchport access vlan 1000

speed 100

duplex full

spanning-tree portfast

L3-Core#1#sh run int vlan 1000

Building configuration...

Current configuration : 108 bytes

!

interface Vlan1000

ip address 10.0.14.1 255.255.255.0

but the port is showing down:

L3-Core#1#sh int g1/12

GigabitEthernet1/12 is down, line protocol is down (notconnect)

I have tried to change cable, but same problem...

What am I missing here????

L3-Core#1#sh ip int brie

Interface IP-Address OK? Method Status Protocol

Vlan1 192.168.222.244 YES NVRAM up up

Vlan1000 10.0.14.1 YES NVRAM down down

GigabitEthernet1/1 unassigned YES unset down down

GigabitEthernet1/2 unassigned YES unset down down

GigabitEthernet1/3 unassigned YES unset down down

GigabitEthernet1/4 unassigned YES unset down down

GigabitEthernet1/5 unassigned YES unset down down

GigabitEthernet1/6 unassigned YES unset down down

GigabitEthernet1/7 unassigned YES unset down down

GigabitEthernet1/8 unassigned YES unset down down

GigabitEthernet1/9 unassigned YES unset down down

GigabitEthernet1/10 unassigned YES unset down down

GigabitEthernet1/11 unassigned YES unset down down

GigabitEthernet1/12 unassigned YES unset down down

Ports in the linecard modul are no problem. they are up when I plug the cord in them...

Jens

1 Reply 1

glen.grant
VIP Alumni
VIP Alumni

Vlan 1000 will not come up unless you have a live port in vlan 1000 . You would have to get alive connection on g1/12 and you will then see the layer3 SVI come active .

Review Cisco Networking for a $25 gift card