Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a MX84 connected to a MS125-24P, which feeds a MS220-8P and a MS120-8. 2 MR33 are directly connected to the MS125 and a 3rd is connected to the MS220. There is also a 4th MR33 acting mesh mode usually connected to the MR33 connected to the M...
I need assisnatce in setting up a 2621 to allow only TCP 1723 and GRE 47 (MS VPN ports) to pass through to a specific internal server.I have 1 static ip for the 2621 router.I have set it up on fe0/0fe0/1 is set up as 192.168.2.1The RAS server is 192....
I think I have a problem with either my router.I can not seem to connect to any ftp sites. I had a power failure a week or so back that out lasted my UPS. Ever since then I have been unable to ftp out. I am not sure if my router has lost some sett...
I think I have a problem with either my router.I can not seem to connect to any ftp sites. I had a power failure a week or so back that out lasted my UPS. Ever since then I have been unable to ftp out. I am not sure if my router has lost some sett...
I think I have solved the issue. So far no more VLAN mismatch errors in the event log.I ended up ensuring that only necessary VLANs were allowed on the trunk links instead of 'ALL'.
Thanks for all the replies.I think I am going to go back to a bridge mode guest network , if for nothing else than a more seamless roaming, but I do want my management traffic completely separate.Perhaps if the alternate management IP feature comes o...
I saw that article, but it doesn't answer the question.VLAN Tagging wireless traffic is not supported in NAT mode. Does this mean is it untagged traffic?Does traffic traverse the native VLAN since it is "untagged?"Or since it is NATing the management...
