About barryjones

barryjones · 03-23-2006

Hi.Got an AP1200 - I have a blue cable console connection. I hold the mode button down, reboot, and get a console session. It logs the interfaces for a bit, but then stops and never gives a console prompt. I've tried break, ctl-c, etc...Any suggestio...

barryjones · 12-27-2005

Hi All.I have an oracle connection from an outside machine to 4 inside machines. The connection is built, but is then torn down with a TCP Reset-I. The connection is ok for 1 internal host, but not the other 3?

barryjones · 11-17-2005

Anyone have any basic gotchas?

barryjones · 03-31-2006

Depending on version - you can go to RME/ADMINISTRATION/INVENTORY/CHECK DEVICE ATTR. or VIEW CHECK RESULTS. This will do a comparison of the device - what's in the cred. inventory db and what creds are on the device.

barryjones · 03-31-2006

The router should contain the following - depending on how much you want to do. You can do software upgrades w/ the RW strings - without them, you cannot:basic would be this-----------------------snmp-server community xxxxxx rosnmp-server community x...

barryjones · 03-31-2006

Or you can use ACL Manager - I think it came w/ RME - but it'll load on LMS.

barryjones · 03-31-2006

I'd recommend adding the user to ACS as well as a local login. Remember, the ACS user id needs a high priv. level.

barryjones · 03-31-2006

The 6500 should have no problems handling these requests - as long as they are not full snmp walks. Even then, it should be ok. Check the Cat CPU usage and snmp engine process during the polls and see what you get.

Member Since	‎03-16-2005 11:02 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	12

User Statistics

User Activity

AP 1200 Console - Boots, logs, but does not go to cmd prompt

PIX 525 - TCP Reset-I (tears down built connection)

Upgrading PIX 515E/525 from 6.3.3 to 7.x.x

Re: Credentials

Re: New to Cisco Works

Re: editing/updating access lists w/ RME

Re: Problem CiscoWorks vs ACS

Re: snmp question