Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Geeks,I have this question. I need steps on how to configure a cisco 1841 to allow my LAN (including firewall) to access the internet.I have this interfaces: ATM0/0/0 , ATM0/1/0, fa0/0 and fa0/1. We need a ppp connection and I have my username a...
Hi Geeks,I have searched the net with answers but still no success to achieving what I needed.My scenario, I 'am replacing my Netcom with a cisco 1841 router. Now, I need advise or better guided steps on how to configure my ATM interface for PPPoE t...
Hi Geeks,I'm a newbie with Cisco and my intention is to connect two physical sites(6kms apart) on fiber preferably single mode. For our discussions, I recommended the Cisco 2960-S 24 port with 2 SFP ports to be used at both ends of our sites. My qu...
Hi Geeks,Im a newbie with cisco here but Im of the intention to setup my new network with cisco equipment and I require some expert advice here.First of all, we have two sites in two different locations, and we are planning to implement fiber between...
Thank you Leo and Kane. I would have to rate both of yours answers as correct since they both enlightened and gave me a much better understanding on the problem solution. Thank you Guys!
Thanks Leo, One final question. once the switch are linked up successfully, does the fiber actually act like a trunk link that will allow any configured VLANS to pass through it between the two switches?? Thanks again.
Hi Leo, Thanks. B/W when you say OS2 you mean Layer 2 standard? Also, what if in the future I would need to add a layer 3 device would it be possible on the OS2 link??Finally for the switch selection, I have a pick on Cisco 2960-S 24 port for both en...
