Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Been attempting to setup Dot1x auth with Microsoft NPS server and have had a really hard time finding documentation for this because everything out there is IBNS 2 with ISE, which I don't have ISE and we aren't planning on getting it at this time....
I used the wizard. To review:1. Make sure your radius client is setup2. The wizard should of created the "connection request policy" which the defaults worked for me.3. For network Policy, the wizard does most everything. To review: Udner Conditions ...
Here is the c9300 config TAC and I got working. We didn't use MAB. I did have to play around with the Windows 10 NIC configuration. The standard stuff in NPS was correct. Let me know if you have questions and I'll do my best to help. aaa new-model...
Hi Thomas, Thanks so much for replying. I've unchecked that hoping that it will prompt for a username and password and it still doesn't. Do you have any other thoughts. Have you seen IBNS 2.0 work with Microsoft NPS server before? I literally can on...
Debug aaa dot1x doesn't work on my switch. Here is the debug dot1x all. I've also included debug aaa authentication & debug aaa authorization at the bottom. Jun 11 14:33:24 MST: dot1x-ev:[Gi1/0/36] Interface state changed to UPJun 11 14:33:24 MST:...
Hi Nitesh,Thanks for your post. I've reviewed both your posts and the first isn't using the IBNS 2.0. The second is using certificates to authenticate, which i'm looking wanting it to prompt for a password.
