Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've somehow been able to get gi2/2 to pass multiple vlan's over a trunk, but now can't seem to duplicate steps on gi2/3, here are the steps I'm trying:Switch#show interfaces trunk
Port Mode Encapsulation Status Native vla...
I have a ISR 4321 at main office and one at remote office running MPLS. I just got it set up and remote office pings across link are around 3msec, but I can't get (almost) any throughput besides pings. Here's a network diagram of what I'm trying to d...
I have an IDS on one SPAN port. Can I copy the same traffic to a different SPAN port also, in case I want to look at that same traffic with another sensor at the same time?
Okay, so I just configured this box and I have snmp/mrtg looking like Gi2/2 might be failing/flapping? I wanted to get another opinion of whether this is an mrtg/snmp issue, or my port is having problems. Have any of you seen something like this befo...
@Richard Burtshere's the output:Switch#show interfaces status
Port Name Status Vlan Duplex Speed Type
Gi1/1 disabled routed full 1000 1000BaseSX
Gi1/2 notconn...
Switch#sh ip int br
Interface IP-Address OK? Method Status Protocol
GigabitEthernet1/1 unassigned YES NVRAM administratively down down
GigabitEthernet1/2 unassigned YES unset down ...
Will IPSec have decent performance? I know it's hard to get exact numbers, but I would like to move "significant" traffic across the link with low latency. Both ends have dedicated gigabit fiber but will eventually be 10gig. I want to transport traff...
If I can't get it to work otherwise, I wonder if I could build a transparent proxy that alters MTU size as it traverses, though I wonder if there's a better way to do what I'm hoping to accomplish?
I'm trying to just traverse public internet between two sites, so I haven't purchased an MPLS service from this provider, I'm just trying to figure out the best way to connect the main office with a remote office, even if it's got an internet connect...
