Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi. Looking for some suggestions as to how to deal with Apple MAC authentication in the SDA world.I have an enterprise VN that handles Windows, Chromebooks, and Apple MACs, using EAP-TLS for authentication, and Authorization policies assigning SGTs ...
Does anyone have a good process for replacing a failed Fabric switch that was originally configured via LAN Automation? I have DNAC 2.2.2.6 but the RMA workflow is not supported for LAN Automated devices, and I can't find any good information. Thank...
I've been setting up a wired and wireless SDA network, and am getting quite used to the DNAC system, but I'm also finding all the little quirks too. Here is the current one... I have some switchports configured for Access Points, and some of the APs...
Hi Folks I'm deploying a new SDA network, primarily to serve wireless APs, but also setting the foundation for a wired network upgrade too. I've deployed Fusion & Border switches (Cat 9500) and single edge switches (Cat 9300L), and all is good. Eac...
Hi. Are there any guides on how best to handle voice services on a SDA network? I have a PoC setup working nicely for data, with .1x auth on the switchports, but I'm struggling to understand how to add the IP phones into the mix, now that there will...
Can you expand on this part: 'Typically you would couple a user certificate authentication with an MDM attribute to establish both user + machine trust'As EAP-TLS is the authentication protocol of choice, how do you trust the machine when the User is...
Manual configuration of an SDA fabric switch that has been configured via LAN Automation is a bad idea. My understanding is that with Fabric Wireless, the telemetry comes from the switchport where the AP is connected, so netflow & nbar config is nee...
***UPDATE*** I have now tried serveral different things including disconnecting APs, returning switchports to default state, removing nbar & netflow from the whole switch, then adding back in. Nothing I've done aids the situation. Time to open a TAC...
Hi Mike DNAC version 2.2.2.6 at the moment. I have gone through several upgrades during the life of the network, and switches have been added over time, and therefore provisioned from different versions of DNAC.
