Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible (and allowed) to have two static mappings to a single IP address? Example:host on inside is 192.168.1.100DMZ has a host 10.0.100.3available public IP is 61.1.1.1 available public IP is 61.1.1.2Is it possible to do a static (inside, out...
Is this scenario possible?:Customer has point to point from A to B using 1720s at both sites. Connection is HDLC. Both sites have independant Internet connections.Customer has a pix firewall at A connected to an ISP and 2600 series router. Pix firewa...
Scenario - User logs into a host that uses ACS for authentication. ACS has a local database. I know it's possible to set ACS to look to AD to find a user if one is not defined in the local database. Is it possible for ACS to look to two Active Direct...
I have a very simple need. I have a 3550 with IOS 12.1(8)EA1c. I have 48 ports. I want to monitor ports 1-47 and shoot the data over to port 48. I used the following commands. In the end port 48 is unreachable and a sho int fast0/48 shows "(monitore...
Is it possible to have an EasyVPN config and remote access into the same box? I tried doing this and when I do a vpnclient enable command it tells me to remote NAT (outside) 0
Thanks but can you be more specific? Can you give me the exact commands? I want to port monitor are fa01-47 and I want the monitor port to be fa48. Thanks. I appreciate it.
Thanks. But then what use is this "feature" if I can't get to the host that is doing the monitoring? The reason I want to do this is so that I can use a sniffer type utility. Short of a cross connect to a hub do I have any other option via IOS? Someo...
