Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have configured a router to initiate a vpn session upon start up using EzVPN config.Think I got it configured successfully.When it authenticate with a VPN 3060, on the telnet session to the router, I am being prompt to ket in the user name and pass...
Hi allI need this urgently, plse help.I am connecting Cat4k to Digital Gigaswitch on 100BTis there a way I can only forward/bridge/route across IP and DecNet protocol BUT drop all others
But this implementation is meant for end user to initiate a VPN tunnel without much technical knowledge.If a telnet session into the router is needed to key in user id and password, then that is too "technical" for the user.is there a way to make th...
I am looking at what happen to the client when it is in the "CROSS" region. will the adapter get confused on APs selection? which AP will client decide to talk to then? Thanks
