Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have successfully configured 5 softphones already. The sixth one shows "not found" when I view phones. I have reviewed all settings, removed and recreated the cti port, etc. It's like a phone with the wrong mac address but this is associated with a...
A rogue consultant attached a 3com switch to my 3550-12 and reset the port. This knocked out user printers and servers and I had to move fast so I reloaded the switch. Is there a way to config the port back to "up" rather than reload the entire switc...
Scenario: Local lan 10.1.1.0 with subnets 10.1.2.0 and 10.1.3.0 (those two are voip system). Also, internal router (2511) for 10.2.4.0 (remote office runs our apps and we run theirs). But we get our web access from our default gateway: the pix 501.I ...
What would cause 3 nat'd static defined web servers to not be able to get past the lower security0 interface? Yet, all clients and non-nat'd servers can. Is this an ISP problem? They have no problem getting out on an old Sonicwall but a pix 501 won't...
I ran softphone on my computer using the credentials of the user and it worked fine. When I then listed softphones in CCM 3.3, it was no longer "not found" but unregistered with an ip of 0.0.0.0. Now, I will test the software at the user's computer a...
Thank you for the workaround. So, rip can't turn the pix into a router even in this case. That was the answer I needed. the pix and the router are on the same subnet now. If we change the default gateway to the router, the apps on the remote subnet w...
Cisco staties in "http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_configuration_guide_chapter09186a0080172786.html" that OSPF is not supported in PIX 501 ver 6.3.
