Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We upgraded from 12.2 to 12.4 We have NAT Logging enabled with the following commands.service timestamps debug datetime localtime show-timezoneservice timestamps log datetime localtime show-timezoneip nat log translations sysloglogging queue-limit 10...
AP1030WiSM 3.2.116.21I have an AP1030 that is losing connectivity to poor SNR. (I'm fixing that, the antenna was installed incorrectly)However, while Diagnosing it, I found this in the message logsWed Aug 23 18:30:49 2006 [ERROR] spam_lrad.c 1799: ...
So we've just purchased a bunch of new network switches (3750's) and our Main computer lab uses WOL to turn on all the computers. The lab is very large, and the they span several VLAN's.We'd like to make WOL work for them again.Any suggestions?
I've exported my AutoDWG files to JPEG via AutoCad raster Print driver. The files look fine when viewed thru windows picture viewer.I import them into a floor area, and they look fine there.I start Map editor up, and they look HORRIBLE. I actually ...
We have several boot disks that we've tried, (which just loads MS lanmanger stuff so we can get images down for Ghosting)when they load the network programs, they freeze. However, if you stick a HUB inbetween the computer and the 3750, it doesn't fr...
Rap to Rap. Yes you can do this. It's called a bridging. But your not doing mesh anymore.The number of Paps that can communicate to a Rap is version dependant. I don't have the Mesh design guide in front of me. The question you should ask is how ...
