I have 2 WAN connections (different ISP's) attached to the FastE ports of a ubr 7100. The router uses route-map statements with the next-hop IP address set according to the least-cost path. I'm not running a routing protocol. Consequently, there's no failover and no load balancing. I have used static routes, but not route-map statements. Would there be any difference in implementing EIGRP on the router using route-map statements than there would be if the router were using statics? Could someone provide me with a link to documentation or a how-to that addresss this situation?
... View more
I support a ubr 7100 with 50 endusers. I would like to set up either failover or load balancing using the 2 DSL lines that are attached. When one of the DSL circuits went down today, none of the endusers could connect to the Internet. I had to reconfigure as follows: no ip name-server nn.nn.130.23 ip name-server nn.nn.28.12 no ip name-server nn.nn.131.5 ip name-server nn.nn.31.12 no route-map Mega permit 10 match ip address 8 set ip next-hop nn.nn.48.1 route-map Mega permit 10 match ip address 8 set ip next-hop nn.nn.12.101 interface FastEthernet0/1 no ip address nn.nn.48.1 255.255.255.0 ip address nn.nn.12.102 255.255.255.252 Any suggestions? I know about routing BGP, but how do I set this up using statics?
... View more