I support a ubr 7100 with 50 endusers. I would like to set up either failover or load balancing using the 2 DSL lines that are attached.
When one of the DSL circuits went down today, none of the endusers could connect to the Internet.
I had to reconfigure as follows:
no ip name-server nn.nn.130.23
ip name-server nn.nn.28.12
no ip name-server nn.nn.131.5
ip name-server nn.nn.31.12
no route-map Mega permit 10
match ip address 8
set ip next-hop nn.nn.48.1
route-map Mega permit 10
match ip address 8
set ip next-hop nn.nn.12.101
interface FastEthernet0/1
no ip address nn.nn.48.1 255.255.255.0
ip address nn.nn.12.102 255.255.255.252
Any suggestions? I know about routing BGP, but how do I set this up using statics?