Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear AllI have a network which segmented to 5 segments (Servers, Staff, Studnets, Guests, DMZ) + two fiber lines for internet connectivity from my ISP.I would like to find a solution which allow me to terminate all segments and internet lines to it t...
I have PIX 515E with 2 interface, inside, outside, I have PAT from inside - outside and NAT from outside to inside.I have installed CISCO ASDM, when I am monitoring the status syslog and droped packet rates I found that, ACL drop packet rate is very...
I have upgrade my Pix515E from IOS 6.2 to 8.0, and ASDM to version 602when I am accessing the ASDM through java site or through the client sw it's asking for AuthenticationAuthentication is requiredplease login to authenticate to pix_ipI don't have a...
Hi guysI have cat 4006 switch in working as core switch with WS4232 routing module. it has a HW failuer and cousing a lot of proplems so I am going to replace it with Cat 4506 Core.currently my config as the following- 4 Network segments (4 Vlans), e...
Hi guysI have cisco cat4006 switch with 4232L3 layer3 routing module installed, I have 1 gigabit FX module installed on G1 interface in the routing module.the system gets hanging frequintly (every 1 or 2 days)at different times, some time its hanging...
No jorge, enable password is working fine through the consol and telnet, even through ASDM also it's accepting the enable password then after that it's asking for this magic authentication password !! I will try it with another pc and let us see how ...
