About thasak

thasak · 07-29-2018

I read few threads about this issue, hovewer there is no sollution that works for me. I can ping both 10.0.0.13 or 10.0.0.14, management vlan works fine on copper, DHCP works on Fa 0/23. Not working: device that try to connect to AP çan't aquire IP a...

thasak · 07-15-2018

I'm strugling to achieve desired network throughput in my network. Something is limiting it to 100mbps and I have no idea what can cause such behaviour. All devices and NICs run at full duplex, 1000mbps. Scenario: I want to transfer large file from...

thasak · 08-19-2018

Yes, thanks I added this, here is my config, all working as it should. However I have quick question, while I'm adding vlan to dot11 ssid, eg. vlan 10 to interface 2g and 5g it says that I cannot set the same vlan on more that 1 interface, when final...

thasak · 08-12-2018

Sorry for my late response, today I made another attempt to troubleshoot that AP and I finally fixed it by erasing everything and entering line by line of my config manualy, and it works now. Thank you all for help!

thasak · 07-29-2018

By default switch interface is going to have this statement: switchport trunk allowed vlan 10, 30 I cannot remove vlan 10 native because I will lose management on AP. I did as you recommended, I set static IP on wireless client but no luck, no acc...

thasak · 07-15-2018

Hi, ok I get your point.PC1 GW is 10.0.0.14/28 nad NAS is 10.0.0.46/29So if I will remove them from router interfaces and apply on vlan interfaces, switch will start working in L3?If so, will I have to sacrifice my zone firewall?

thasak · 07-15-2018

Hi, actually it is working in L3 mode, thanksCLI v1.0set system mode router

Member Since	‎07-15-2018 06:10 AM
Date Last Visited	‎08-24-2018 02:02 AM
Posts	7

User Statistics

User Activity

DHCP won't cross the trunk

Help with optimizing network

Re: DHCP won't cross the trunk

Re: DHCP won't cross the trunk

Re: DHCP won't cross the trunk

Re: Help with optimizing network

Re: Help with optimizing network