Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is anyone able to advise if 1 or 2 CPUs are required in B200 M5 to run 2 x NVME disks in the front bays?(C220 M5 and C240 M5 require 2 x CPUs to run 2 x NVME, but i can't find anything specific for B200 M5... is it the same for these?)Thanks!
I've got a weird issue with both of my C220 M5SX servers. I powered down my complete home lab to physically move/roll the rack 10metres across the room to a better spot, and now they are failing to power on/post. They are UCS managed and hooked direc...
Is anyone able to advise from real life experience how loud 6332-16UP fabric interconnects are during idle/low usage? I'm weighing up moving to these for my home lab, but am concerned about trying to know how loud they are first. I had 2 x 6248UP fir...
I've trailing some C220 M5 servers in my UCS Mini (with B200 M4s) home lab and just wanted to clarify the right disk and boot policy settings for this setup. The servers have a UCS-MSTOR-M2 module with 240GB SSD and also a UCSC-SAS-M5 controller with...
've got some B200 M4s and C220 M5s and all are running the Cisco TPM 2.0 (UCSX-TPM2-002) The modules are functioning fine and are reported correctly but don't appear to work with the new TPM Encryption feature in ESXi 7.0 U2. vCenter throws up a nice...
Just confirming when i posted the original question, I didn't have any issues with the drive working, it was more so that the P-SATA controller was not updating as per UCSM policies.I've since re-configured these servers as non-UCS managed and have n...
If you're doing a clean install/upgrade to 7.0 U3 then the only alert I would expect to see is related the TPM recovery key backup.Is this the alert you were getting?I configure my setup as the following:UEFI Boot ModeSecure Boot EnabledThe attached ...
What alert is you seeing in vCenter?Are they configured to boot as UEFI? Are they configured to use secure boot?Are you trying to configure TPM sealing? If so, run this command on a ESXi host and let me know the output:esxcli system settings encrypti...
